Owner's Manual

How to Connect:

1 Loosen the terminal knob.

2 Insert the bare wire end properly into the terminal

hole.

[Remove the insulation from both ends of the

speaker cable.]

3 Tighten the knob and secure the cable.

Test the firmness of the connection by pulling

lightly on the cable at the terminal.

10 mm

Speaker (R)

Speaker (L)

Note

Do not let the bare speaker wires touch each other

as this could damage the speaker or the amplifier,

or both of them.

Black (–)

Red (+)

Speaker output

terminals of the

amplifier

Amplifier

CONNECTION TO YOUR AMPLIFIER

BEFORE MAKING CONNECTIONS, MAKE SURE THAT THE AMPLIFIER IS SWITCHED OFF.

Loosen

■ Connections

• Connect the screw-type input terminals at the rear of

the speakers to the speaker output terminals of your

amplifier with the provided speaker cables.

• Connect the (+) terminals on both the amplifier and

the speakers using one side of the speaker cable.

Connect the (–) terminals on both components using

the other side of the cable.

• Connect one speaker to the left (marked L) terminals

of your amplifier, and another speaker to the right

(marked R) terminals, making sure not to reverse the

polarity (+, –). If one speaker is connected with

reversed polarity, the sound will be unnatural and

lack bass.

Tighten