Service manual

INSP
ADJ
BATTERY INSPECTION
3-17
ELECTRICAL SYSTEM
BATTERY INSPECTION
1. Remove:
• Battery cover
See “REAR BODYWORK” section
2. Inspect:
The fluid level between the maximum
and minimum marks.
Incorrect

Refill
ATTENTION:
Add only distilled water; tap water contains
minerals which are damaging to the battery.
3. Inspect:
• Battery terminals
Dirty terminals

Clean with a wire
brush
Bad connection

Correct
NOTE:
Once the terminals are clean, apply a thin
cover of grease.
4. Check:
• The density of the electrolyte
Less than 1,280

Recharge the battery
Charge current:
0.3 Amps/10 Hrs
Electrolyte density:
1,280 at 20 °C (68 °F)