Specifications

The Maximum Range of Soundbeam is the furthest distance from the within which
interruptions of the Beam will be detected. It can be set to any distance from 0.56m to
6.00m. The Default Range is 0.60m and, unless you change the Default Range setting,
0.60m will be selected each time you Load up a Set-up.
Range
Note that interruptions of the first 20 cm of the Beam from the Sensor will not result in any
notes being triggered.
At this point, there are two possibilities you might like to try.
First, If you have plenty of clear space - 5m x 5m, say - you could try extending the length
of the beam to 3m. This is done by positioning your mouse cursor over the Maximum
Range Slider and clicking your left mouse button, dragging the Slider to the right in-
creases the active length of the beam, drag the Slider until the Maximum Range setting
is 3m.
If you wish to increment the Range in steps of 1 cm to fine tune the length of the beam,
try using the Left and Right arrow buttons next to the maximum range window.
Desktop Soundbeam Manual Page 21