Service manual

IGNITION SYSTEM
7-3
EAS27150
TROUBLESHOOTING
The ignition system fails to operate (no spark or intermittent spark).
NOTE:
• Before troubleshooting, remove the following part(s):
1. Seat
2. Fuel tank
3. Air filter case
4. Battery box
5. Engine
NG →
OK ↓
NG →
OK ↓
NG →
OK ↓
OK →
NG ↓
NG →
OK ↓
NG →
OK ↓
NG →
OK ↓
1. Check the fuses.
(Main, ignition, and ECU)
Refer to “CHECKING THE FUSES”
on page 7-93.
Replace the fuse(s).
2. Check the battery.
Refer to “CHECKING AND
CHARGING THE BATTERY” on
page 7-94.
• Clean the battery terminals.
• Recharge or replace the battery.
3. Check the spark plugs.
Refer to “CHECKING THE SPARK
PLUGS” on page 3-8.
Re-gap or replace the spark plug(s).
4. Check the ignition spark gap.
Refer to “CHECKING THE
IGNITION SPARK GAP” on page
7-100.
Ignition system is OK.
5. Check the spark plug caps.
Refer to “CHECKING THE SPARK
PLUG CAPS” on page 7-99.
Replace the spark plug cap(s).
6. Check the ignition coils.
Refer to “CHECKING THE
IGNITION COILS” on page 7-99.
Replace the ignition coil(s).
7. Check the crankshaft position
sensor.
Refer to “CHECKING THE
CRANKSHAFT POSITION
SENSOR” on page 7-100.
Replace the crankshaft position sensor.