Owner`s manual

Internal Structure (System Overview)
139
Basic Structure
Owner’s Manual
● Loop Recording (Pattern)
Pattern repeats the rhythm pattern of several measures (1 to
256 measures) in a “loop,” and its recording is also done using
loops. This method is used when recording a Pattern Phrase
using the Overdub method (above). As shown in the example
below, notes that you record will play back from the next
repetition (loop), letting you record while hearing previously
recorded material.
When recording a rhythm of Bass Drum, Snare Drum,
Hi-Hat cymbal in order:
n Loop Recording can only be used with Realtime recording.
● Punch In/Out (Song)
You can use this method when you want to re-record only over
a specific area of the track. You’ll need to set the start and end
points before re-recording.
In the eight-measure example below, the third measures
through the fifth measure are re-recorded.
n Punch In/Out Recording can only be used with Realtime recording.
n Note that the Punch In/Out method always replaces (destroys) the
original data over the specified area.
[PATTERN] ➞ [REC] (Record) ➞ [F1] SETUP ➞ loop = on
Loop 1st round
Loop 2nd round
Loop 3rd round
Bass Drum
Snare Drum
Bass Drum
Hi-Hat
Snare Drum
Bass Drum
1234567 8
1234567 8
Recording start Recording stop
Punch in Punch out
Newly recorded data
Before re-recording
After re-recording