User Manual

4. Screens

MMP1 Operation Manual 45

NOTE

• Speaker Sets can be set in the MMP1 Editor.

• Up to 12 channels can be displayed as the send destinations.

If there are 13 or more channels on the Main Monitor, only the

first 12 channels will appear here.

• Area

2 of the image will appear differently depending on

whether you used the Setup Wizard or not when configuring

basic settings.

When Setup Wizard is not used, buttons to select the Main

Monitor for output destinations will appear as below.

Turn Talkback on (green)/off.

NOTE

You can set Talkback interrupt destinations in the MMP1 Editor.

1 Ta p t h is .

2 Drag the pointer to adjust.

3 Tap to turn headphone output on (light blue).

This is the headphone output level. Slide

this up and down to make minor

adjustments in ±0.1 dB increments.

Meters

Displays Main Monitor meters.

Values less than -20 dB are displayed in

green , values less than 0 dB in

yellow , and values equal to or above

that in red . Peak hold circuits are not

displayed.

NOTE

Up to 12 Main Monitor channels are

displayed. If there are 13 or more

channels on the Main Monitor, only the

first 12 channels will appear here.

Double tap with two fingers to mute all

output. Double tap with two fingers again

to cancel the mute all function.

Tap here to turn the dimmer on (green) or

off. Turn this on to lower Monitor output

for the DIM Level without changing the

Monitor Source Level.

NOTE

The DIM Level can be set on the Main

Monitor screen in Editor view.

Tap to turn mute on (orange) or off for

Monitor output.