User Manual

4. Screens
MMP1 Operation Manual 23
EQ Graph
Select a Speaker Matrix Out to change the EQ settings.
Drag the pointer of each band to change the frequency
and the gain.
Drag or use the mouse wheel to change six EQ
parameters (Frequency, Gain, Q). Double click to enter a
value. Out-of-range values entered will be corrected to the
maximum or minimum value allowed. To return these
parameters to their default values, simultaneously hold
down the <Ctrl> key (Windows) or the <command> key
(Mac) and click on the corresponding control. Default
values are F: 125 Hz/355 Hz/3.55 kHz/6.3 kHz, G: 0 dB,
and Q: 4.0 (Shelf)/1.4 (Peak)/1.0 (Notch). You can also
select the EQ type from Peak and Shelf (Shelving), or
Peak and Notch.
Direct Speaker Send
For selecting input sources to send to each speaker
without going through the speaker matrix. Delay, EQ and
other processing cannot be performed.
This is used to switch between Speaker Sets when the
speaker matrix is being used for another application.
Click to select an input source.
NOTE
The same items can be configured on the
“Input Patch” tab on the Patch screen.