User Guide

17
Normal Mode
Increase by 10
Section Control Tempo Control
STATUS F0 Ft
DATA/CTRL c01 - c42 030- 250
BANK MSB/MAX Channel Number (if c41, c42 is used) –
BANK LSB/MIN ––
TOGGLE ON-OFF
––
/NUMBER OF PGM
4 Press [INC/YES] or [DEC/NO] to edit parameter values.
Press [INC/YES] to increase the value shown in the LED
display by 1, press [DEC/NO] to decrease the value by 1. By
holding a button, values will continuously increase or decrease.
Hold the [INC/YES] button and press the [DEC/NO] button
and the value shown in the LED display will increase by 10.
Repeatedly press [DEC/NO] to continue increasing the value
by 10.
Hold the [DEC/NO] button and press the [INC/YES] button
and the value shown in the LED display will decrease by 10.
Repeatedly press [INC/YES] to continue decreasing the value
by 10.
DEC
/NO
INC
/YES
±10
DEC
/NO
INC
/YES
±10
DEC
/NO
INC
/YES
±10
001 128
128 001
*(—) is displayed to indicate parameters that cannot be selected.
WRITE
/EXIT
F07
5 After the desired parameters have been edited in steps 3 and 4,
press [WRITE/EXIT]. The Memory Number shown in the
LED display will flash.
• If data has not been edited, the Memory Number will
not flash and the MFC10 will return to its normal
control mode.
6 Press [INC/YES], to save the edited data to the current
Memory Number, The MFC10 will return to its normal control
mode.
Press [DEC/NO] to cancel the save operation of the edited
data. At this time the memory will revert to its pre-edited
condition.
Decrease by 10
DEC
/NO
INC
/YES
±10
• Another Memory Number from the same bank (10’s digit bank) can be easily edited by pressing [1] - [0]
without exiting from the edit mode. You must execute or cancel the save operation for the currently
edited data (the current Memory Number will flash) before proceeding to edit the new number. Use [INC/
YES] to execute or [DEC/NO] to cancel the save operation. If data has not been edited, the Memory
Number will not flash and the newly selected Memory Number will be shown in the display.
DEC
/NO
INC
/YES
±10
DEC
/NO
INC
/YES
±10