Owner's Manual

19
English
3
Connect the power amplier to the
speakers.
For each channel speaker, connect the cables
from the speaker’s mid/high range terminals
to the amplier’s SPEAKERS A jacks of the
corresponding channel, and from the speaker’s
low range terminals to the amplier’s SPEAKERS
B jacks of the corresponding channel respectively.
4
Set the MODE selector on the rear panel to
NORMAL.
5
Set the SPEAKERS selector on the front
panel to A+B BI-WIRING.
CAUTION
Be sure to use speakers that feature the impedance shown
in the table below.
Speaker impedance
SPEAKERS selector A B A+B
Basic connection/
Bi-wiring connection
4Ω or higher 8Ω or higher
Bi-amp connection 4Ω or higher 8Ω or higher
Bridge connection 8Ω or higher 16Ω or higher*
* Excluding models for U.S.A. and Canada
CAUTION
Before turning the power back on to the source component,
rst lower the volume level on that component.
B
B
High
Low
High
Low
MODE: NORMAL
M-5000
SPEAKERS
OFF
A
B
A
+
B
WIRING
BI
Remove the shorting bar.
L channel
L channel
SPEAKERS selector
(front panel)