Owner`s manual

Trouble Recovery
83
EMU29471
Replacing fuse
If a fuse has blown, remove the electrical
cover, open the fuse holder and remove the
fuse with a fuse puller (if equipped). Replace
it with a spare one of the proper amperage.
WARNING
EWM00630
Be sure to use the specified fuse. An in-
correct fuse or a piece of wire could allow
excessive current flow. This could cause
electric system damage and a fire hazard.
NOTE:
Consult your Yamaha dealer if the new fuse
immediately blows again.
EMU29523
Power trim and tilt will not operate
If the engine cannot be tilted up or down with
the power trim and tilt because of a dis-
charged battery or a failure with the power
trim and tilt unit, the engine can be tilted
manually.
1. Loosen the manual valve screw by turn-
ing it counterclockwise until it stops.
2. Put the engine in the desired position,
then tighten the manual valve screw by
turning it clockwise.
1. Electrical cover
2. Fuse holder
3. Fuse (20 A × 3, 30 A, 60 A × 2)
4. Spare fuse (20 A, 30 A, 60 A)
5. Fuse puller
3
5
4
1
3
4
3
2
ZMU01903
1. Fuse (20 A × 3, 30 A, 60 A × 2)
2. Fuse puller
1. Manual valve screw
1
2
ZMU01904
1
ZMU01905