Owner's Manual

LS9 Editor Owner’s Manual
34
I ATTACK
Specifies the time from when the key-in signal exceeds the threshold level until the signal starts being compressed.
J GAIN
Adjusts the gain of the signal after it has passed through the compressor.
K RELEASE
Specifies the time from when the key-in signal falls below the threshold level until compression is removed.
L KEY IN SOURCE
Click this to select the key-in signal that you want to use.
The choices are the same as for GATE.
If DE-ESSER is selected
A TYPE
This indicates that De-Esser is the currently selected type.
B LIBRARY
This button accesses the dynamics library. Clicking this button will open the DYNAMICS page of the LIBRARY
window.
C ON
This button switches the de-esser on/off.
D Response curve
Indicates the response for the de-esser of the currently selected channel.
E GR meter
This meter indicates the amount of gain reduction produced by the de-esser.
F THRESHOLD
Specifies the threshold level at which the de-esser will operate. The input signal will start being compressed when
the key-in signal exceeds this level; compression will be removed when the signal falls below this level.
G FREQ. (Minimum frequency)
Specifies the minimum frequency at which the key-in signal will activate the de-esser.
H KEY IN SOURCE
This indicates the key-in signal that will be used. It is fixed at SELF POST EQ.
1
4
7
6
8
2 35