User Manual

Detailed settings for the voices [VOICE SETTING]
CLP-380 Owner’s Manual
87
Detailed Settings
The pitch of a note can be shifted upward or downward in
steps of an octave.
See the procedure on page 80.
In Dual mode:
Setting range:
-2 (two octaves lower) – 0 (no pitch shift) – +2 (two octaves
higher)
You can set the volume level for each voice part.
See the procedure on page 80.
In Dual mode:
Setting range:
0 – 127
You can specify the position in the stereo image from
which you hear the sound.
See the procedure on page 80.
In Dual mode:
Setting range:
L64 (hard left) – C (center) – R63 (hard right)
The pitch of the two sounds selected in Dual mode can be
“skewed” slightly away from each other.
See the procedure on page 80.
Setting range:
-20 – +20 (Positive (+) settings will raise the pitch of the first
sound and lower the pitch of the second sound. Negative (–)
settings will do the opposite.)
In Dual mode, parameters with the “*” mark are set for Voice 1 and Voice 2 individually.
Parameter names enclosed in parentheses ( ) are displayed in Dual mode.
Setting the octave
[Octave]*
Setting the volume level
[Volume]*
B
D
NO YES
A
C
Main Set?-->
Octave 0
B
D
NO YES
A
C
MainxLayer Set?-->
Octave(GrndPno1) 0
Voice for editing (Voice 1 or Voice 2)
B
D
NO YES
A
C
Main Set?-->
Volume 100
B
D
NO YES
A
C
MainxLayer Set?-->
Volume(GrndPno1) 100
Voice for editing (Voice 1 or Voice 2)
Setting the position of right and left
channels
[Pan]*
Make fine adjustments to the pitch
(only in Dual mode)
[Detune]
B
D
NO YES
A
C
Main Set?-->
Pan C
B
D
NO YES
A
C
MainxLayer Set?-->
Pan(GrndPno1) C
Voice for editing (Voice 1 or Voice 2)
B
D
NO YES
A
C
MainxLayer Set?-->
Detune + 3