User Manual

Before Using the Clavinova
CLP-380 Owner’s Manual
15
Introduction
1. Connect the power cable.
First insert the plug of the power cable into the AC connector on the Clavinova, then plug the other end of the cable into the proper
AC outlet on the wall. For an illustration of the location of the [AC IN] connector, see “Panel Controls and Terminals” (page 10).
In some areas a plug adaptor may be provided to match the pin configuration of the AC wall outlets in your area.
WARNING
Make sure your CLP-380 is rated for the AC voltage supplied in the area in which it is to be used (voltage rating appears on the name
plate on the bottom panel). In some areas, a voltage selector may be provided on the bottom panel of the main keyboard unit near the
power cord. Make sure that the voltage selector is set for the voltage in your area. Connecting the unit to the wrong AC supply can
cause serious damage to the internal circuitry and may even pose a shock hazard!
Use only the AC power cord supplied with the CLP-380. If the supplied cord is lost or damaged and needs to be replaced, contact
your Yamaha dealer. The use of an inappropriate replacement can pose a fire and shock hazard!
The type of AC power cord provided with the CLP-380 may be different depending on the country in which it is purchased. (In some
areas a plug adaptor may be provided to match the pin configuration of the AC wall outlets in your area.) Do NOT modify the plug pro-
vided with the CLP-380. If the plug will not fit the outlet, have a proper outlet installed by a qualified electrician.
2. Turn on the power to the Clavinova.
Press the [POWER] switch located on the right of the keyboard to turn the power on.
The screen located in the center of the front panel and the power indicator located below the left end of the keyboard lights up.
Press the [POWER] switch again to turn off the power to the Clavinova.
The screen and the power indicator turn off.
You can adjust the contrast of the display by turning the [CONTRAST] knob located to the right of the LCD.
Turning the power on
Adjusting the display contrast
1-1
(The shape of plug differs depend-
ing on locale.)
(rear panel)
1-2
B
D
NO YES
A
C
Grand Piano 1
When you turn on the power to the Clavinova, a voice name appears on
the screen.
Power indicator
If you close the key cover without
turning the power off, the power
indicator remains lit, indicating that
the power is still on.
TIP
[POWER] switch
Power indicator
CAUTION
Even when the instrument is
turned off, electricity is still
flowing to the instrument at the
minimum level. When you are
not using the instrument for a
long time or during electrical
storms, make sure you unplug
the AC power plug from the wall
AC outlet.
CONTRAST
EXIT
B
D
NO YES
A
C
Contrast
Difference between brightness and
darkness.
TERMINOLOGY
Use this knob.