Specifications

CHAS
L-172
FRONT FORK INSTALLATION
Reverse the “REMOVAL PROCEDURE”
Note the following points
1. Install
• Front Fork
• Temporarily tighten Pinch Bolt
(Underbracket) ¿
NOTE:
Pull up the inner to until its end flushes with the
top of the Handle Crown then temporarily tighten
the bolts (underbracket)
2. Tighten
• Pinch Bolts (underbracket) ¿
• Cap Bolts À
Pinch Bolt (Underbracket) :
28Nm (2.8 m.kg, 20 ft.lb)
Bolt (Cap Bolt) :
23Nm (2.3 m.kg, 17 ft.lb)
FRONT FORK
6-26
9. Fill :
• Fork Oil ¿
10. After filling up, slowly Pump the Fork up
and down to distribute the Fork Oil
11. Install :
• Front Fork Spring ¿
• Seat Upper
• Spacer
12. Install :
• Cap Bolt Temporarily to avoid oil drain.
NOTE :
• Install the Fork Spring with its smaller Pitch
upward.
• Before installing the Cap Bolt, apply grease to
the O-Ring.
Oil Quantity :
Overhauling - 165 ± 3 ml
Refilling - 153 ± 4 ml
Recommended Oil :
Teleshocab Oil