User Manual

Other functions
Reference Manual
199
• DANTE 48 k
• DANTE 44.1 k
The word clock supplied from the Dante jack on the rear panel of the console will be used as the
clock source.
•SLOT 1–3
The word clock supplied via a digital I/O card installed in a console slot will be used as the clock
source. Word clock can be selected in pairs for each slot.
3 Clock status display
Indicates the status of synchronization with the master clock for each clock source. Each indicator
is explained below:
•LOCK (light blue)
Indicates that a clock synchronized with the selected clock source is being input. If an external
device is connected to the corresponding connector or slot, input/output is occurring properly
between that device and the CL series console. If the sampling frequency is close, this status may
be displayed even if not synchronized.
• LOCK, BUT NOT SYNC’ED (yellow)
A valid clock is being input, but is not synchronized with the selected clock source. If an external
device is connected to the corresponding connector, input/output cannot occur correctly between
that device and the CL series console.
• SRC ON (green)
This is a special status applied only to SLOT 1–3, indicating that the corresponding channel’s SRC
(Sampling Rate Converter) is enabled. This means that even if the signal is not synchronized,
normal input/output with the CL series console is occurring.
• UNLOCK (red)
A valid clock is being input, but the CL series console is not synchronized to the selected clock.
If an external device is connected to the corresponding connector, it will be unable to
communicate properly with the CL console.
• UNKNOWN (black)
This indicates that the clock status cannot be detected because no external device is connected or
because there is no valid clock input. You will be able to select this connector/slot, but successful
synchronization cannot occur until a valid connection is established.
If the indicator for the port selected as the clock source has turned light blue, and the clock
frequency appears in the upper left of the MASTER CLOCK SELECT field, this indicates that the
CL series console is operating correctly with the new clock.
NOTE
• If the indicator for the selected clock does not turn light blue, make sure that the external device
is correctly connected, and that the external device is set to transmit clock data.
• Noise may occur at the output jacks when the word clock setting is changed. To protect your
speaker system, be sure to turn down the power amp volume before changing the word clock
setting.
• If you attempt to select a channel (for which SRC is on) as the word clock source, a message will
appear, warning you that the sampling rate converter will be disabled.
■ SLOT SETUP field
This field enables you to make various settings related to the MY slots on the rear panel of the console.
1 Card name
Indicates the type of card installed in the slot. If nothing is installed, “----” will appear.
2 SRC buttons
The SRC (Sampling Rate Converter) function can be switched on or off for a slot in which an MY
card (MY8-AE96S) that features the SRC function is installed. If another type of card is installed,
or if no card is installed, no SRC button will appear.
3 FREQUENCY display
Indicates the sampling frequency of input signals if the installed card can detect the substatus of
input signals, such as an AES/EBU card. If another type of card is installed, or if no card is
installed, “----” will appear.
4 EMPHASIS STATUS display
Indicates the emphasis information of input signals if the installed card can detect the substatus
of input signals, such as an AES/EBU card. If another type of card is installed, or if no card is
installed, “----” will appear.
3. In the MASTER CLOCK SELECT field, select a clock source.
4. To close the WORD CLOCK/SLOT popup window, press the “x” symbol located in
the upper right.
You will return to the SETUP screen.
5. To close the SETUP screen, press the SETUP button in the Function Access Area.
1
3
2
4