User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
List of settings in “Settings” dialog boxes Appendix
MTX-MRX Editor User Guide
246
Switch settings
Select the following parameter types to be controlled by the switches, and then make
the appropriate settings.
•Input Ch Send On
•Input Ch Send Level
❍ [DEVICE]
Select the device that you want to change. These are shown in order of UNIT ID and
model name.
❍ [PARAMETER1]/[PARAMETER2]
In the [PARAMETER1] column, select the target ZONE.
For Input Ch Send On, click the ? at the left of the channel name in the
[PARAMETER2] column to select ON, OFF, or IGNORE for the desired channels.
“On” can be specified only for one channel.
For Input Ch Send Level, set the following parameters as well.
❍ [Inc]
If you select this option, pressing the switch each time will raise the level or the send
level.
✦[Upper Limit]
Specifies the maximum level achieved when you press the switch.
✦[Minimum]
If the current parameter value is lower than the value specified here, pressing the
switch once will set the parameter to this value.
❍ [Dec]
If you select this option, pressing the switch each time will lower the level or the send
level.
✦[Lower Limit]
Specifies the minimum level achieved when you press the switch.
✦[Mute Enable] check box
If this is on, the Mute state (–∞ dB) will be enabled if the level is lowered below the
value specified by [Lower Limit].
❍ [Switch]
Allows you to make switch-related settings.
[Sensitivity] specifies the sensitivity at which the parameter will change when the
switch is pressed.