AV Receiver Owner's Manual

87 En
Troubleshooting
English
ADDITIONAL
INFORMATION
■ Remote control
■ Resetting the system
Use this feature to reset all the parameters of this unit to
the initial factory settings.
1 Press
A
STANDBY/ON on the front panel to
set this unit to the standby mode.
2 Press and hold
K
TONE CONTROL and
then press
A
STANDBY/ON to turn on this
unit.
The advanced setup menu appears in the front panel
display.
3 Press
L
PROGRAM l / h to select “INIT.”.
4 Press
M
STRAIGHT repeatedly to select
“RESET”.
Select “CANCEL” to cancel the initialization
procedure without making any changes.
5 Press
A
STANDBY/ON to confirm your
selection and set this unit to the standby
mode.
• This procedure completely resets all the parameters of this unit
including the “SET MENU” parameters. However, the
advanced setup menu parameters will not be initialized.
• The initial factory settings are activated next time you turn on
this unit.
y
To cancel the initialization procedure at any time without making
any changes, press
M
STRAIGHT repeatedly to select
“CANCEL” and then press
A
STANDBY/ON.
Problem Cause Remedy
See
page
The remote control
does not work nor
function properly.
Wrong distance or angle. The remote control functions within a maximum
range of 6 m (20 ft) and no more than 30 degrees
off-axis from the front panel.
23
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.
Reposition this unit.
—
The batteries are weak. Replace all batteries.
3
The remote control code is not correctly
set.
Set the remote control code correctly using “List of
remote control codes” at the end of this manual.
75
Try setting another code for the same manufacturer
using “List of remote control codes” at the end of this
manual.
75
Even if the remote control code is
correctly set, there are some models that
do not respond to the remote control.
Notes
01EN_HTR-6140_U.book Page 87 Friday, February 1, 2008 2:26 PM