Manual

• Downmixing to 2 channels
You can enjoy 2-channel stereo playback even fronl nmlti-
chanuel sources.
Rotate PROGRAM (or press STEREO on the
remote control) to select 2ch Stereo.
PROGRAM
Front panel
or
STEREO HALL JAZZ ROCK
OO
_r]/OTS N_HT EYJES _TRAIGHT
OO @
EFFECT
Remote control
•" t" i"' ,i .............
,:,,,,,,,,: : ,,,,,,,,,,,,,: ,,,,,,,,,
-&
YOUcan use a subwoofer with this progranl when SWFR or
BOTH is selected in "BASS OUT".
• Listening to unprocessed input signals
Ill STRAIGHT mode, two chaunel stereo sources are
output from only the front left and right speakers Multi-
channel sources are decoded straight into the appropriate
channels without any additional effect processing
Press STRAIGHT (EFFECT) to select STRAIGHT.
STRAIGHT
or
Front panel Remote control
t"'"i"i"H"lTl"'ii"i"
",lt'rh..llt"H"Jl
Press STRAIGHT (EFFECT) again so that "STRAIGHT"
disappears from the display when you want to turn the
sound effect back on.
• Virtual CINEMA DSP
Virtual CINEMA DSP allows you to enjoy tile CINEMA
DSP programs without surround speakers. It creates
virtual speakers to reproduce the natural sound field.
If you do not connect surround speakers, Virtual CINEMA
DSP activates automatically whenever you select a
CINEMA DSP sound field pr%ram.
Virtual CINEMA DSP will not activate, even when "SURR L/R
SP" is set to NONE (see page 53) in the following cases:
When MULTI CH INPUT is selected as the input source.
When headphones are connected to the PHONES .jack.
This unit comes with a variety of input jacks. Do the
I_llowing to select the type of input signals you want to
use,
1 Rotate INPUT to select the input source.
iNPUT
2 Press INPUT MODE to select an input mode.
In most cases, use AUTO.
INPUT MODE
%
r"_ii i"_ cii ii i_ ....
Input source Input mode
l"l'...'"lJi"i_"'l_'...' Automatically selects input signals in
the fullov,,ing order:
1) Digital signals"
2) Analog signals
,....rv'r":::',...., Selects only digital signals encoded in
DTS. If no DTS signals are input, no
sound is output.
,....""i"J""i.,,..'.,,....,...,,..._r'":::Selects only analog signals. If no
analog signals are input, no sound is
output.
':: If this unit detects a Dolby Digilal or DTS signal, the
decoder automatically swilches to the appropriale sound
fiekl program.
-4¢--
You can atljusl the dehmlt input mode this unil selecls when Ihe
power is turned on (see page 58).
36