Guitar Performance Effector Owner's Manual
MANUAL EFFECT FACTORY SET PARAMETER CHART 143
SUPPLEMENTAL INFORMATION
MANUAL EFFECT FACTORY SET PARAMETER CHART
MANUAL EFFECT FACTORY SET PARAMETER CHART
on=
●
/off=
×
Effect Type Parameter Value
×
Comp Attack
*
Sense
Output
×
Dist 1~4, Od Drive
*
Tone
Output
×
Equalizer Low Gain
*
Low Middle Gain
High Middle Gain
High Gain
Input 100%
Low Frequency 140Hz
Low Mid Frequency 700Hz
High Mid Frequency 1.2kHz
High Frequency 3.6kHz
Low Mid Q 2.0
High Mid Q 2.0
Output 100%
Wah+EQ Type
*
Sense or Speed
Center Frequency
Range
Feedback 0%
Input 100%
Low Gain 0dB
Low Frequency 125kHz
High Gain 0dB
High Frequency 3.6kHz
Output 100%
Amp Simulator+ Type
*
EQ Low Gain
High Gain
Mix
Input 100%
Low Frequency 200%
High Frequency 3.6kHz
Output 100%
×
Chorus1 Speed
*
Brilliance
Depth
Mix 75%
AMD 0%
Dry 50%
Chorus2 Speed
*
Brilliance
Depth
Mix 75%
Dry 50%
Pitch Shifter Pitch L
*
Pitch R
Mix
L Delay Time 0.1ms
L Delay FB 0%
R Delay Time 0.1ms
R Delay FB 0%
Dry 100%
Note: The sub parameter values here are default settings
that are automatically called up in the Memory Edit
mode when the effect type is changed. Main param-
eters, however, remain the same (or proportionally the
same, if different ranges exist for different types).
on=
●
/off=
×
Effect Type Parameter Value
Flanger Speed
*
Feedback
Depth
Mix 75%
L Delay Time 3ms
R Delay Time 6ms
Dry 50%
Phaser Speed
*
Feedback
Depth
Mix 75%
Dry 50%
×
Reverb Time
*
High
Mix
Reverb Type Hall
Low Gain 0dB
Dry 100%
Delay (Tap) Time
*
Feedback
Mix
Doubling Time 50ms
Doubling Balance 55%
Dry 100%
Delay+Reverb Delay Time
*
Delay Mix
Reverb Mix
Delay Feedback 25%
Doubling Time 50%
Doubling/Dry Balance 55%
Delay Dry 100%
Reverb Type Hall
Reverb Time 2.6sec
Reverb Low Gain 0dB
Reverb High 0.5
Reverb Dry 100%
Utility Connect cmp, dst, eq, cho, rev
Settings
Group —
Foot Controller cho-rev
Minimum Volume 0
Auto Volume 5
Noise Gate 3
Factory Set Values for Other Functions
Foot Switch
ASSIGNABLE Type switch
Pitch 440Hz
Chord C, Am, F, G
Control Change 91~95
* Main parameter settings depend on the parameter knob position.