User Manual

24
When necessary
Checking the speed
Tocheckandadjustthespeed,followthestepsbelow.
1
Connect the strobe light to the STROBE
jack on the rear panel of the unit.
2
Place the stroboscopic disc on the
platter.
3
Press the speed button repeatedly to
select the rotation speed.
4
Press the START/STOP button.
The platter starts to rotate and the strobe light
turns on.
5
Shine the strobe light onto the
stroboscopic disc.
6
Use the PITCH ADJUST to adjust the
speed.
RotatethePITCHADJUSTinthe+or−direction
untiltherelevantherringboneringonthe
stroboscopic disc appears to be stationary.
Note
• YoucanusethePITCHADJUSTtoadjustthespeed
while the record is being played.
Foradjustmentstepsandrange,refertothe
“Specications”sectiononpage28.
• Theadjustedspeedwillberetainedafterthepowerto
theunitisturnedo.
• The stroboscopic disc and strobe light included in the
packageshouldbeusedonlyforthisunit.Whenyou
checkthespeed,usebothofthemtogether.
Care
Caring for this unit
Wipetheunitwithasoftdrycloth.Ifthenishofyour
unitispianoblack,werecommendusingacleaningcloth
made for pianos. Do not use chemicals such as benzine or
thinner, since they might damage the surface.
Caring for the record stylus
The tip of the record stylus is extremely delicate. Handle
it with care so that it is not damaged. If dust should
adhere to the tip of the stylus, use a soft pointed brush to
wipeitostartingatthebaseofthestylusandmoving
towardthetip,oruseacommercially-availablecleaner
made for that purpose.
Note
Before you clean or perform maintenance on the unit or
stylus,besuretoturnothepowertotheunit.
Caring for records
Dirtadheringtoarecordcancauseskipsornoise.Usea
commercially-availablerecordcleanertoremovedirt.