User Guide

8-38
SIGNALING SYSTEM
ELEC
NO
YES NO
The wiring circuit
from the main switch
to the tail/brake light
coupler is faulty and
must be repaired.
This circuit is OK.
YES
1. Turn signal indicator light (LEDs)
S Check the turn signal indicator light for conti-
nuity.
Refer to “CHECKING THE LEDs”.
S Are the turn signal indicator light OK?
Replace the meter
assembly.
EAS00799
3. The turn signal/position light, turn signal
indicator light or both fail to blink.
YES
2. Turn signal switch
S Check the turn signal switch for continuity.
Refer to “CHECKING THE SWITCHES”.
S Is the turn signal switch OK?
Replace the left han-
dlebar switch.
3. Voltage
S Connect the pocket tester (DC 20 V) to the
turn signal relay coupler (wire harness side)
as shown.
Negative tester probe ! ground
Positive tester probe ! brown/green
1
S Turn the main switch to “ON”.
S Measure the voltage (DC 12 V) on brown/
green at the turn signal relay coupler (wire
harness side).
S Is the voltage within specification?
1
YES NO
The wiring circuit
from the main switch
to the turn signal
relay coupler is faulty
and must be re-
paired.
YES NO
4. Voltage
S Connect the pocket tester (DC 20 V) to the
turn signal relay coupler (wire harness side)
as shown.
The turn signal relay
is faulty and must be
replaced.
Positive tester probe ! ground
Negative tester probe ! brown/white
1
S Turn the main switch to “ON”.
S Measure the voltage (DC 12 V) on
brown/white at the turn signal relay cou-
pler (wire harness side).
S Is the voltage within specification?
1
5. Voltage
S Connect the pocket tester (DC 20 V) to the
turn signal/position light connector or meter
assembly coupler (wire harness side) as
shown.
Front turn signal/position light
Rear turn/signal light
Turn signal indicator light
A
B
C
NO