User Manual

raised, the noise produced during conversion will decrease, but the high

frequency range will be cut.

Specify the sampling frequency after conversion. The available range is

11,000Hz-64,000Hz.

5.8. Convert Bit Size ...

This command converts the sample size (number of bits) of the sound data.

5.9. Add Channel...

This command adds a silent channel to the currently open sound data. If you

execute the [Add Channel...] command on monaural data, it will become stereo

data with one side of silence.

5.10. Delete Channel...

This command deletes the specified channel from multi-channel sound data. If

you execute the [Delete Channel...] command on stereo data, it will become

monaural data.

5.11. Swap Channels...

This command exchanges the waveforms of two specified channels within multi-

channel sound data.

5.12. Import From Sampler...

When an external Yamaha sampler (A3000/4000/5000, EX5/5R/7) is connected via

SCSI, this command loads sound data from the sampler into TWE.

*If you are using an A3000/4000/5000, you must first select MIDI function in

Utility mode, and turn off the Bulk Dump Protect setting.

* If you are using an EX5/5R/7, only those samples which are stored in DRAM

can be transmitted to TWE. Samples stored in FLASH cannot be transmitted. If

you wish to transmit samples stored in FLASH to TWE, you must execute the

Copy Sample function on the EX to copy the desired sample from FLASH to

DRAM, and then execute TWE's [Import From Sampler...] command.

- 4 -