Music Synthesizer Models EX5, EX5R, EX7 Owner's Manual 4th Edition

134
Voice Mode
■ KeyFollow
Sets the KeyFollow for the peak frequency change.
This KeyFollow function controls the first peak
frequency in accordance with the notes played on
the keyboard. When set to “+32,” the KeyFollow
functions at 100% and the peak frequency moves in
proportion to the pitch played on the keyboard.
When set to a value of “0” the peak frequency is
fixed.
❏ Settings: –32~0~+64
■ EG Depth (Envelope Generator Depth)
Sets the EG depth that affects the peak frequency.
❏ Settings: –64~0~+63
■ EG Depth Vel (Envelope Generator Depth
Velocity)
Sets the velocity sensitivity for the EG depth. The
EG depth can be controlled by the velocity at which
the note played on the keyboard.
❏ Settings: –64~0~+63
■ EG Mode(Envelope Generator Mode)
Sets the EG mode (the way in which the EG
functions). There are two types of modes.
❏ Settings:
decay: The EG effect decays.
attack: The EG effect increases.
■ EG Time (Envelope Generator Time)
Sets the amount of time from when the note is
played to when the EG terminates.
❏ Settings: 0~127
■ EG Time Kflw (Envelope Generator Time
KeyFollow)
Sets the KeyFollow for the EG Time. This KeyFollow
function controls the amount of the EG time in
accordance with the notes played on the keyboard.
When set to a positive value, the higher the note
played on the keyboard, the shorter the EG time
becomes. When a negative value is set, the lower the
note played, the shorter the EG time becomes.
❏ Settings: –64~0~+63
■ ReleaseTime
Sets the EG release time (the time from key-off until
the sound ends).
❏ Settings: 0~48
■ LFO Depth (Low Frequency Oscillator Depth)
Sets the depth of the LFO wave.
❏ Settings: 0~127
■ LFO Speed (Low Frequency Oscillator Speed)
Sets the frequency of the LFO wave. The higher the
value, the faster the speed.
❏ Settings: 1~255
■ Feedback
Sets the amount of phaser feedback. The larger the
value, the more the frequency peaks are emphasized,
resulting in pronounced sounds.
❏ Settings: –64~0~+63
■ Feedback Vel (Feedback Velocity)
Sets the velocity sensitivity for the amount of
feedback. The amount of feedback can be controlled
by the velocity at which the note played on the
keyboard.
❏ Settings: –64~0~+63
■ Wet Level
Sets the output level for the signal that is affected by
the phaser. You can adjust the FDSP (Phaser)
balance by combining this parameter and the Dry
Level below.
❏ Settings: –64~0~+63
■ Dry Level
Sets the output level for the original input signal.
❏ Settings: –64~0~+63
■ Pan
The same as the one in the EP Pickup. See page 126
for information.
Voice/E.qx 5/21/98 11:31 AM Page 134