Specifications

83
Registration Memory
6
Resetting the Electone to the Factory Preset (Power On Reset)
All current settings including Registration Memories, User voices and User
rhythms can be deleted at once by using the Power On Reset function.
To reset the all settings:
1
Turn off the power.
2
While holding down the top left Data Control button, turn the power
back on.
Turning the Electone off erases all panel settings you have made. When
the Electone is turned on, Basic Registration 1 is automatically selected.
If you have made panel settings you wish to keep, save them to
Registration Memory before turning the Electone off.
You can, however, restore the panel settings that were made before the
Electone was last turned off. In doing this, first be careful NOT to press
any panel buttons (excepting those in Basic Registration) after you turn
the Electone back on. Then, to restore the previous settings, hold down
the M./TO DISK (Memory) button and press D. (Disable) button.
13 14 15 16 1 2 3 4 5 6 7 8 9 10 11 12 D.
M.
EL-700
/TO DISK
POWER
Be careful when using this operation,
since it erases all your existing data.
Always save your important data to a
floppy disk using M.D.R. (page 84) in
advance.