Owner's Manual

E-77
ADVANCED
OPERATION
English
REMOTE CONTROL FEATURES
Cautions
•“AGAIN” appears in the display window when a button other
than the macro buttons is pressed.
• If you want to change the source component, use SOURCE
SELECT
/ or input selector buttons. When you use the
input selector buttons, selecting the input is programmed as a
macro step, whereas SOURCE SELECT
/ only changes
the component.
3
3
Press the buttons of the functions that you want to
include in the macro operation sequence in order.
You can set up to 10 steps (10 functions). After you have set 10
steps, “FULL” appears and the remote control automatically
exits from the macro mode.
Example: Programming a macro for DVD
If the button that you want to program as the first macro step is
pressed, “MCR 1” appears. In a few seconds, “M:DVD” and
“DVD” appear and you can program the next button.
Caution
•“NG” appears in the display window when programming has
not been done correctly. In this case, start over from step 2.
4
4
Press MACRO again when the operation sequence
you want to program is complete.
Caution
•“ERROR” appears in the display window under the following
circumstances:
1 when pressing more than one button at once
2 when MACRO ON/OFF is switched to another position
MACRO