User Manual

Chapter 6 Component Guide

DME Designer Owner’s Manual

441

Double-click the component to open the component editor. The component editor is the same for the

16-input and 24-input types, the only difference being the number of channels. The Simple Mixer

component editor is organized into input channel and master output sections.

Section Parameter Setting Range Function

1 Input Channel EQ Details Opens the EQ editor window.

2 High Gain -18.0 to +18.0 dB Sets the gain of the EQ High band.

3 Mid Gain -18.0 to +18.0 dB Sets the gain of the EQ Mid band.

4 Low Gain -18.0 to +18.0 dB Sets the gain of the EQ Low band.

5 AUX1 Send -∞ to +10.0 dB Sets the AUX1 send level.

6 AUX2 Send -∞ to +10.0 dB Sets the AUX2 send level.

7 AUX1 Send Point Pre/Post Switches the AUX1 send point to pre-

fader (Pre) or post-fader (Post).

8 AUX2 Send Point Pre/Post Switches the AUX2 send point to pre-

fader (Pre) or post-fader (Post).

9 Pan L63 – Center – R63 Sets the pan position.

) Pair ON/OFF Engages paired operation for odd

and even channel pairs. (excluding

Pan, PFL, and AUX Send operation).

When turned ON the odd-channel

parameters are copied to the even

channel. When ON Pan functions in

LR Nominal mode (nominal level

when pan is full left or right) and

when OFF Pan functions in Center

Nominal mode (nominal level when

pan is center).

! On ON/OFF Turns the input of each channel ON.

@ Fader -∞ to +10.0 dB Sets the input level for each input

channel.

)