Data Sheet

821
371
247
906 (Screw heads included)
900 (Screw heads NOT included)
968
883
unit : mm
DM2000VCM
GENERAL SPECIFICATIONS
Internal processing 32bit (Accumulator=58bit)
Number of scene memories 99
Sampling frequency rate Internal : 44.1kHz, 48kHz, 88.2kHz, 96kHz
External: Normal rate 44.1kHz (-10%) to 48kHz (+6%)
Double rate 88.2kHz (-10%) to 96kHz (+6%)
Signal Delay Less than 2.3 ms CH INPUT to STEREO OUT (@fs=48 kHz)
Less than 1.2 ms CH INPUT to STEREO OUT (@fs=96 kHz)
Total harmonic distortion*
1
CH INPUT to STEREO OUT
Input Gain=Min.
Less than 0.05%, 20Hz to 20kHz @+14dBu into 600Ω
Less than 0.01%, 1kHz @+18dBu into 600Ω
(@fs=48kHz)
Less than 0.05%, 20Hz to 40kHz @+14dBu into 600Ω
Less than 0.01%, 1kHz @+18dBu into 600Ω
(@fs=96kHz)
Frequency response
CH INPUT to STEREO OUT
20Hz - 20kHz, 0.5, -1.5dB, @+4dBu into 600Ω (@fs=48kHz)
20Hz - 40kHz, 0.5, -1.5dB, @+4dBu into 600Ω (@fs=96kHz)
Dynamic range
(maximum level to noise level)
110dB typ, DA Converter (STEREO OUT)
108dB typ, AD+DA (to STEREO OUT) (@fs=48kHz)
106dB typ, AD+DA (to STEREO OUT) (@fs=96kHz)
Hum & noise level*
2
(20Hz to 20kHz)
Rs=150ohms
Input Gain=Max
Input Pad=0dB
Input Sensitivity=-60dB
-128dBu Equivalent Input Noise
-92dBu residual output noise. STEREO OUT(STEREO OUT off)
-92dBu(96dB S/N) STEREO OUT(STEREO fader at nominal
level and all CH INPUT faders at minimum level)
-64dBu(68dB S/N) STEREO OUT(STEREO fader at nominal level
and one CH INPUT fader at nominal level)
Crosstalk (@1kHz)
Input Gain=Min.
80dB adjacent input channels (CH1-24)
80dB input to output
Phantom Power +48V
Power requirements Japan: AC100V 50/60Hz
North America: AC120V, 60Hz
Other Areas: AC220-240V, 50/60Hz
Power consumption 300W
Dimensions (W x H x D) DM2000: 906 x 257 x 821mm (35.7" x 10.2" x 32.3")
With MB & SP: 968 x 371 x 883mm (38.1" x 14.6" x 34.8")
Weight DM2000: 43.0kg (94.8lbs)
With MB & SP: 51.6kg (113.8lbs)
DIMENSIONS
*1 Total harmonic distortion is measured with a 18dB/Oct filter @80kHz.
*2 Hum & noise level is measured with a 6dB/oct filter @12.7kHz; equivalent to 20kHz filter with
infinite dB/Oct attenuation.
ANALOG INPUT SPECIFICATIONS
ANALOG OUTPUT SPECIFICATIONS
DIGITAL INPUT SPECIFICATIONS
DIGITAL OUTPUT SPECIFICATIONS
CONTROL I/O SPECIFICATIONS
Input terminal
Actual
source
impedance
For use with
nominal
Input level
Connector
PAD GAIN
Sensitivity Nominal
Max.
before clip
CH INPUT
A/B 1-24
0
-60dB
3kΩ
50-600Ω Mics
& 600Ω Lines
-70dBu -60dBu -46dBu
A:XLR3-31 type*
B:TRS Phone
Jack*
-16dB
-26dBu -16dBu -2dBu
26 0dBu +10dBu +24dBu
INSERT IN 1-24 10kΩ 600Ω Lines -6dBu +4dBu +18dBu
TRS Phone Jack*
2TR IN ANALOG 1[L,R] 10kΩ 600Ω Lines +4dBu +4dBu +18dBu TRS Phone Jack*
2TR IN ANALOG 2[L,R] 10kΩ 600Ω Lines -10dBu -10dBV +4dBV RCA Pin Jack**
Output terminal
Actual source
impedance
For use with
nominal
GAIN SW
Output terminals
Connector
Nominal
Max.
before clip
STEREO OUT[L,R]
600Ω 10kΩ Lines — -10dBV +4dBV RCA Pin Jack**
75Ω 600Ω Lines — +4dBu +18dBu XLR3-32 type*
STUDIO MONITOR
OUT[L,R]
75Ω 10kΩ Lines — +4dBu +18dBu
TRS Phone Jack*
C-R MONITOR OUT
LARGE[L,R]
75Ω 600Ω Lines — +4dBu +18dBu XLR3-32 type*
C-R MONITOR OUT
SMALL[L,R]
75Ω 600Ω Lines — +4dBu +18dBu XLR3-32 type*
OMNI OUT 1-8 75Ω 10kΩ Lines
+18dB
(default)
+4dBu +18dBu
TRS Phone Jack*
+4dB -10dBu +4dBu
INSERT OUT 1-24 75Ω 10kΩ Lines — +4dBu +18dBu
TRS Phone Jack *
PHONES 100Ω
8Ω Phones — 4mW 25mW
ST Phone Jack**
40Ω Phones — 12mW 75mW
Terminal Format Data length Level Connector
2TR IN DIGITAL
1 AES/EBU 24bit RS422 XLR3-31 type
2 AES/EBU 24bit RS422 XLR3-31 type
3 IEC-60958 24bit 0.5Vpp/75Ω RCA Pin Jack
CASCADE IN — — RS422
D-sub Half Pitch Connector
68Pin (Female)
Terminal Format Data length Level Connector
2TR OUT DIGITAL
1
AES/EBU
(Professional use)
24bit RS422 XLR3-32 type
2
AES/EBU
(Professional use)
24bit RS422 XLR3-32 type
3
IEC-60958
(Consumer Use)
24bit 0.5Vpp/75Ω RCA Pin Jack
CASCADE OUT — — RS422
D-sub Half Pitch Connector
68Pin (Female)
Terminal Format Level Connector
TO HOST
Serial — RS422 Mini DIN Connector 8P
USB USB1.1 0 V~3.3 V B Type USB Connector
MIDI
IN MIDI — DIN Connector 5P
OUT MIDI — DIN Connector 5P
THRU MIDI — DIN Connector 5P
TIME CODE IN
MTC MIDI — DIN Connector 5P
SMPTE SMPTE Nominal –10dB/10kΩ XLR3-31 Type*
WORD CLOCK
IN — TTL/75Ω (ON/OFF)*
1
BNC Connector
OUT 1, 2 — Nominal –10dB/10kΩ BNC Connector
CONTROL — Open collector D-Sub Connector 25P (Female)
REMOTE — RS422 D-Sub Connector 9P (Male)
KEYBOARD PS/2 — DIN Connector 6P
STORAGE CARD — — SmartMedia slot
METER — RS422 D-SUB Connector 15P (Female)
LAMP (
with MB2000) — 0-12V XLR4-31 Type
*1. This switch is on the rear panel.