User Manual

76 Chapter 5—Digital I/O & Cascading

DM2000 Version 2—Owner’s Manual

Attenuating Cascade Inputs

Cascade Inputs can be attenuated, and the Cascade mode and Cascade source can be spec-

iﬁed on the Cascade In page.

1 Use the DISPLAY ACCESS [DIO] button to locate the Cascade In page.

2 Use the cursor buttons to select the parameters, and use the Parameter

wheel, INC/DEC buttons, or [ENTER] button to set them.

CASCADE MODE: When you want to output the same signals from two DM2000s, turn

on the BI-DIRECTIONAL button. In this case, the Cascade connections are looped. Turn

on the CASCADE MASTER option on one of the DM2000s to make it the master console.

When the BI-DIRECTIONAL button is off, the last DM2000 in the cascade is automatically

conﬁgured as the master console and it output the ﬁnal signals.

CASCADE IN FROM: This is used to specify the type of device connected to the CAS-

CADE IN port, either DM2000 or 02R. When a DM2000 or 02R96 is connected to the CAS-

CADE IN port, DM2000 is speciﬁed automatically.

CASCADE IN ATTENUATOR: These controls are used to attenuate Cascade Input sig-

nals. You can copy the currently selected setting to all Attenuator parameters by dou-

ble-clicking the [ENTER] button.

Turning On & Off Cascade Outputs

Individual Cascade Outputs can be turned on or off as follows.

1 Use the DISPLAY ACCESS [DIO] button to locate the Cascade Out page.

2 Use the cursor buttons to select the ON/OFF buttons, and use the [ENTER]

button to set them.