Owner's Manual
Table Of Contents
- SPECIAL MESSAGE SECTION
- IMPORTANT SAFETY INSTRUCTIONS
- Mounting the Control Unit to the Disklavier GranTouch
- Welcome to the Yamaha Disklavier™ GranTouch™!
- Important
- Table of Contents
- Chapter 1 Setting Up Your Disklavier GranTouch
- Chapter 2 Names of Parts and Their Functions
- Chapter 3 Disks Used with the Disklavier GranTouch
- Chapter 4 Turning On/Off Your Disklavier GranTouch
- Chapter 5 Playing the Disklavier GranTouch Digital Piano
- Chapter 6 Display (LCD) and DRIVE Indicator
- Chapter 7 Basic Playback
- Playing Back a Floppy Disk or a Memory Disk
- Playing Back a CD
- Specifying a Disk
- Starting Playback
- Pausing Playback
- Stopping Playback
- Selecting Songs with the Control Unit
- Selecting Songs with the Remote Control
- Fast Preview & Review
- Fast Forward & Reverse
- Adjusting the Playback Volume
- Balancing the Ensemble Volume (TG Master Balance)
- Balancing the CD Volume (CD Master Balance)
- Changing the Tempo
- Transposing a Song
- Adjusting the Pitch of Audio CDs
- Chapter 8 Repeat Playback
- Chapter 9 Auto Start & Space Playback
- Chapter 10 Useful Functions for Learning Piano
- Chapter 11 More Playing Features
- Chapter 12 Advanced Ensemble Song Playback
- Chapter 13 Using the AUX Connectors
- Chapter 14 Using the SmartKey™ Feature
- Chapter 15 Internal XG Tone Generator Voice & Drum Kit List
42
Operating the Pedals
Yourself
During playback, the Disklavier GranTouch
pedals play the pedal data that was recorded with
the song. If, however, you want to practice your
pedal playing, you can cancel pedal playback and
play them yourself.
The Pedal Cancel function is set in the Control
Unit.
1
Hold down [PART L] and [PART R]
until “PDoff” appears on the
display.
You can now play the pedals yourself.
“PDoff” remains on the display until the
pedals are turned on again.
2
To turn the pedals back on, hold
down [PART L] and [PART R] until
“PD on” appears on the display.
“PD on” flashes on the display for a few
seconds, then goes off.
The pedals now play as normal.
Using the Built-in
Metronome
The Disklavier GranTouch’s built-in metronome
can be used for practice playing, playback, and
recording. You do not need to play back a song to
use this function.
With each beat of the metronome a digital click is
produced by the Control Unit. The click can be
turned off. In addition to the click, the LED volume
indicators function as a visual metronome. On the
first beat of each measure, all the indicators flash.
On the remaining beats, the left half and right half
of the indicators flash alternately.
All metronome parameters are reset when a disk
is ejected or when the Disklavier GranTouch is
turned off.
1
Press [METRONOME].
The METRONOME indicator lights, the
metronome starts, and the following display
appears.
The continuing display shows the
following.
The c symbol is used to show the currently
selected parameter. It is moved by pressing
[<] and [>].
PART
L
R
PART
L
R
METRO-
NOME
13
2
–10 –8 –6 –4 –2 0
1st beat
2nd beat
3rd beat
4
5