User Guide

Using the DG-Stomp

First, connect a guitar to the DG-Stomp and try some sounds.

■ Produce Sound

1. Before connecting, turn off the power on the DG-

Stomp and connect a guitar to the INPUT jack

on the rear panel.

When connecting a high impedance guitar set

the switch to LOW ( ), set the switch to HIGH

( ) when connecting a low impedance guitar.

2. After rotating the OUTPUT knob to the “0” posi-

tion, turn the POWER switch (STAND-BY) to ON

( ).

Turning the POWER switch ON when the OUTPUT

knob is turned up may result in damage to devices

such as amplifier, speaker, headphone, etc., or

cause unexpected accidents like damage to your

hearing due to a high volume setting.

3. A 3-digit number “011” will appear on the dis-

play.

The numbers (Group number: 0, Bank number:

1, Patch number: 1) refer to the patch that is

currently selected.

Note: When the patch’s number is shown on the

display the device is in a condition called the

PLAY MODE. When in the PLAY MODE, it is

possible to select a patch and use the knobs

or buttons to change settings to play.

For now use this patch to try and produce some

sound.

4. Play a chord on the guitar and rotate the OUT-

PUT knob to the right to control the volume.