User Manual

MON/CUE function
240 PM5D/PM5D-RH V2 / DSP5D Owner’s Manual Reference section
J Level meter
These peak level meters indicate the level of the output
signal from the MONITOR OUT jacks. You can select
the level detection point to be immediately before the
delay that is provided on the MONITOR/CUE bus
output (when the PRE DELAY button is on) or imme-
diately after the delay (when the POST DELAY button
is on).
K MONITOR / CUE DELAY
Here you can make settings for the delay function pro-
vided on the MONITOR/CUE bus output. Use the
knob to specify the delay time (0–1000 msec), and use
the ON/OFF button to switch the delay on/off. If the
ON/OFF button is on, the monitor signal and cue sig-
nal will be delayed by the specified time. The delay time
units can be changed in the DELAY SCALE field found
in each screen of the INPUT DELAY/OUTPUT
DELAY function.
L MONITOR LEVEL
The level of the signal sent from the MONITOR OUT
jacks is set by the level (digital) you adjust here together
with the level (analog) adjusted by the MONITOR
[LEVEL] knob on the top panel of the PM5D.
M MONITOR OUT
Switches the signal sent from the MONITOR OUT
jacks on/off.
Here you can make settings and perform operations
related to the Cue/Solo function.
A SOLO ON/OFF
This button selects either
CUE mode or SOLO mode
as the type of monitoring
performed by the [CUE] key.
When you turn this button
on, a confirmation message
will appear. Each mode
operates as follows.
• CUE mode (SOLO ON/OFF
button is off)
The signal of the channel
whose [CUE] key is pressed
will be sent to the dedicated
CUE bus, and monitored via
the CUE bus from the CUE
OUT jacks, MONITOR
OUT jacks (if CUE INTERRUPTION is on), and
PHONE jack. This mode lets you monitor the signal of
a specific channel without affecting other buses.
• SOLO mode (SOLO ON/OFF button is on)
When using Input Solo, the familiar “solo” function is
enabled; only the signal of the channel whose [CUE]
key is pressed will be sent to the MIX, MATRIX, and
STEREO A/B buses, and other channels will be muted.
When using Output Solo, only that channel will be on.
The signal of a channel whose [CUE] key is pressed can
also be monitored from the CUE OUT jacks, MONI-
TOR OUT jacks, and PHONES jack.
B CUE MODE
This button selects one of the following two possibili-
ties for when the [CUE] key of more than one channel
is pressed.
• MIX CUE mode
All channels / DCA groups whose [CUE] key is on will
be mixed for monitoring.
K
J
L
M
CUE/SOLO screen
CUE/SOLO
1
2
3