Owner's Manual

CVP-601 Owner’s Manual

Assembly

CAUTION

• Assemble the stand on a flat floor with ample space.

• Be careful not to confuse parts, and be sure to install all parts in

the correct direction. Please assemble in accordance with the

sequence given below.

• Assembly should be carried out by at least two persons.

• Be sure to use the correct screw size, as indicated below. Use of

incorrect screws can cause damage.

• Be sure to tighten up all screws upon completing assembly of

each unit.

• To disassemble, reverse the assembly sequence given below.

Remove foamed styrol pads from the package, position

them on the floor, then place A on top of them. Position

the pads so that they will not hide the connectors on the

bottom of A.

Remove all parts from the box. Confirm that all parts shown

in the illustration are provided.

1 Attach C to D and E.

1 Untie and straighten out the bundled pedal cord.

Do not discard the vinyl tie. You will need it later

in step 5.

2 Attach D and E to C by tightening four long

screws (6 x 20 mm).

reparation Before Assembling

Have a Phillips-head (+) screwdriver of the appropriate

size ready.

Foamed styrol pads

Main Unit

Back panel

Pedal Box

Bundled pedal cord inside

Side panel (left) Side panel(right)

Holder set

For details on how to set the holders, refer to page 94.

Assembly

6 x 20 mm long screws x 4

6 x 16 mm short screws x 6

4 x 12 mm thin screws x 2

4 x 20 mm tapping screws x 4

Cord holders x 2

Power cord

Headphone hanger

4 x 10 mm thin screws x 2

Assembly parts