Owner's Manual

CVP-601 Owner’s Manual
103
Troubleshooting
The measure number is different from that of
the score in the Song Position display, shown
by pressing the [REW]/[FF] buttons.
This happens when playing back music data for which a specific, fixed
tempo is set.
When playing back a Song, some channels
do not play.
Playback of these channels may be set to “OFF.” Turn playback ON for
those channels that are set to “OFF” (page 62).
The Guide lamps do not light during Song
playback, even after pressing the [GUIDE]
button.
Any notes outside of the 88-key range cannot be indicated by the Guide
lamps.
The Guide lamps light an octave or two lower/
higher than the actual pitch.
The Guide lamps sometimes light an octave or two lower/higher than the
actual pitch depending on the selected Voice.
The tempo, beat, measure and music
notation is not displayed correctly.
Some Song data for the instrument has been recorded with special “free
tempo” settings. For such Song data, the tempo, beat, measure and
music notation will not be displayed correctly.
USB Audio function
The message “This drive is busy now.”
appeared, and then the recording was
aborted.
Make sure to use a compatible USB flash memory (page 91).
Make sure that the USB flash memory has enough memory (page 92).
If you are using a USB flash memory to which data has already been
recorded, check first that no important data remains on the device, then
format it (page 92) and try recording again.
Audio files cannot be selected. The file format may not be compatible with the instrument. The compatible
formats is only WAV. The DRM protected files cannot be played back.
Recorded file is played back at a different
volume compared to when it was recorded.
The audio playback volume has been changed. Setting the volume value
to 100 plays back the file at the same volume as when it was recorded
(page 75).
Mixing Console
The sound seems strange or different than
expected when changing a rhythm Voice
(drum kit, etc.) of the Style or Song from the
Mixer.
When changing the rhythm/percussion Voices (drum kits, etc.) of the Style
and Song from the VOICE parameter, the detailed settings related to the
drum voice are reset, and in some cases you may be unable to restore the
original sound. In the case of Song playback, you can restore the original
sound by returning to the beginning of the Song and playing back from
that point. In the case of Style play, you can restore the original sound by
selecting the same Style again.
Pedal/AUX Pedal
The damper, sostenuto and soft functions do
not work for the relevant pedals.
The pedal cord plug is not connected. Securely insert the pedal cord plug
into the proper jack (page 99).
Make sure that each pedal is properly assigned to SUSTAIN,
SOSTENUTO, and SOFT (page 34).
The on/off setting of the footswitch
connected to the AUX PEDAL jack is
reversed.
Turn the instrument’s power off, then turn it on again without pressing the
footswitch.
AUX IN jack
Sound input to the AUX IN jack is interrupted. The output volume of the external device connected to this instrument is
too low. Increase the output volume of the external device. The volume
level reproduced via this instrument’s speakers can be adjusted by using
the [MASTER VOLUME] control.
Song