Operation Manual

52 CVP-509/505/503/501 Reference Manual

Songs – Recording Your Performances and Creating Songs –

Re-Recording a Speciﬁc Section—Punch In/Out

When re-recording a speciﬁc section of an already-recorded Song, use the Punch IN/OUT function. In this

method, only the data between the Punch In point and the Punch Out point is overwritten with the newly

recorded data. Keep in mind that the notes before and after the Punch In/Out points are not recorded over,

although you will hear them play back normally to guide you in the Punch In/Out timing.

1 Call up the operation display.

[FUNCTION] → [F] DIGITAL REC MENU → [A] SONG CREATOR → TAB [E][F] REC MODE

2 Determine the settings for recording.

[1 ▲▼]–

[3 ▲▼]

REC START

(Punch In)

Determines the Punch In timing.

NORMAL

Overwrite recording starts when pressing the SONG [PLAY/PAUSE] but-

ton or when you play the keyboard in the Synchro Standby mode.

FIRST KEY ON

The Song plays back normally, then starts overwrite recording as soon as

you play the keyboard.

PUNCH IN AT

The Song plays back normally up to the beginning of the indicated Punch

In measure, then starts overwrite recording at that point. You can set the

Punch In measure by pressing the [3 ▲▼] button.

[4 ▲▼]–

[6 ▲▼]

REC END

(Punch Out)

Determines the Punch Out timing.

REPLACE ALL

This deletes all data after the point at which recording is stopped.

PUNCH OUT

The Song position at which recording is stopped is regarded as the Punch

Out point. This setting maintains all data after the point at which record-

ing is stopped.

PUNCH OUT AT

Actual overwrite recording continues until the beginning of the speciﬁed

Punch Out measure (set with the corresponding display button), at which

point recording stops and normal playback continues. This setting main-

tains all data after the point at which recording is stopped. You can set the

Punch Out measure by pressing the [6 ▲▼] buttons.