Owner`s manual
Adjust the Volume Balance and Changing Voices
— Mixing Console
CVP-210/208
128
Usually an equalizer is used to correct the sound output from amps or speakers to match the special character of the
room. The sound is divided into several frequency bands, allowing you to correct the sound by raising or lowering the
level for each band. The equalizer allows you to adjust the tone or timbre of the sound to match the performance space,
or to compensate for certain acoustic characteristics in your room. For example, you can cut some of the low range
frequencies when playing on stages or in large studio spaces where the sound is too “boomy,” or boost the high
frequencies in rooms and close spaces where the sound is relatively “dead” and free of echoes. The CVP-210/208
possesses a high grade five-band digital equalizer function. With this function, a final effect—tone control—can be
added to the output of your instrument.
The explanations here apply to step 2 of the procedure on page 123.
Adjusting the Sound to Match the Performance
Environment — EQ
F
J
I
H
G
A
E
D
C
B
SOUND
CREATOR
DIGITAL
RECORDING
MIXING
CONSOLE
PAR T
DIGITAL
STUDIO
F
J
I
12345678
H
G
A
E
D
C
B
GAIN
Q
FREQFREQ
Select this to call up the
MASTER EQ display. Use the
[1▲▼] - [8▲▼] buttons to adjust
the EQ High parameters (amount
of gain of the high frequency) for
each part.
Use the [1▲▼] - [8▲▼] buttons
to adjust the EQ High parameters
(amount of gain of the low
frequency) for each part.
Use the [1▲▼] - [8▲▼]
buttons to adjust the EQ
Low parameters (amount
of gain of the low
frequency) for each part.
Selects a Master EQ type.
Select a MASTER EQ type.
Whenever an EQ band is edited, the corresponding EQ value
is highlighted and the number of the edited band appears
above the Q and FREQ controls. The Q and FREQ controls
can then be used to adjust the Q (bandwidth) and the FREQ
(center frequency) of the selected band. The higher the “Q”,
the narrower the bandwidth. The available FREQ range is
different for each band.
The PRESET and USER curves can be
edited as required via the corresponding
buttons. Each of the five bands can be
boosted or cut by up to 12 dB.
Adjusts the overall gain of all
EQ bands simultaneously.
This lets you store your edited
PRESET or USER curve to
USER 1 or USER 2.
Each press of this button
switches among the
various parts/channels.