Operation Manual

155
CVP-205/203
CVP-203: Keyboard Stand Assembly
CAUTION
■ Be careful not to confuse parts, and be sure to
install all parts in the correct direction. Please
assemble in accordance with the sequence given
below.
■ Assembly should be carried out by at least two
persons.
■ Be sure to use the correct screw size, as indicated
below. Use of incorrect screws can cause damage.
■ Be sure to tighten up all screws upon completing
assembly of each unit.
■ To disassemble, reverse the assembly sequence
given below.
1
Open the package, take out the pedal box, take
out the styrofoam pads, and place the main unit
on top of the pads.
Position the pads so that they will protect the headphone
jack and the connector panel located underneath the
front left corner, and the floppy disk drive located
underneath the front right corner.
Remove the parts shown below from the box.
2
Attach the side panels to the pedal box.
3
Attach the rear panel.
1 Place the bottom edges of the rear panel on the feet’s protruding
edges, with the panel slightly angled as shown in the illustration.
The wooden pattern side of the panel should be facing outside.
Then, align the top part of the panel with the side panels.
2 Secure the top of the rear panel to the side panel brackets using
two 4x12 mm thin screws.
3 Secure the bottom of the rear panel to the pedal box using four
4x20 mm tapping screws.
4
Mount the main unit.
Be sure to place your hands at least 10 cm from either
end of the main unit when positioning it.
Have a Phillips-head (+) screwdriver ready.
Floppy disk drive
Styrofoam
pads
Main unit
Bundled pedal cord inside
Rear panel
Pedal box
Side panel
(left)
Side panel
(right)
Assembly Parts AC power cord
6 x 25 mm long screws x4
4 x 20 mm tapping screws x46 x 16 mm short screws x4
Cord holders x2
4 x 12 mm thin screws x2
Side panel
(left)
Side panel
(right)
Side panel
(left)
Side panel
(right)
1 Untie and straighten out the bundled
cord attached to the bottom of the
pedal box. Don’t discard the vinyl tie,
you’ll need it later in step 6.
2 Use the four 6x25 mm long screws to attach the pedal box.
First attach one side panel, then attach the other side panel.
CAUTION
• Fingers can become pinched between the main unit and
the rear or side panels, be extra careful so as not to drop
the main unit.
• Do not hold the keyboard in any position other than the
position shown in the illustration.
At least
10 cm