Owner`s manual

5 Leave enough room behind the drive for connecting the power, SCSI and

audio cables. Then tighten the four fastening screws on the sides of the unit

by hand to hold the drive in place.

6 Remove the SCSI adapter card from the computer and turn its termination

OFF so that internal SCSI devices may be connected. Refer to the

documentation that came with your SCSI adapter card for further details.

n Some SCSI adapter cards are capable of auto-termination.

If your card is of this type, you will

not need to remove it from its slot since you will not need to set any of its switches or jumpers.

SCSI adapter card

Installation

6416S_e15.qx 6/29/99 6:00 PM Page 23