CD Recorder Owner's Manual

Chapter 2 - Installing the Yamaha CRW4261t Drive

MASTER/SLAVE settings

Before you install the CRW4261t in your computer, you must make the

MASTER/SLAVE setting.

This setting is set by inserting a jumper pin in the jumper switch

located on the rear panel of the CRW4261t drive.

Important:

When the unit is shipped from the factory, this setting is in the MASTER

position.

Note:

Use long-nose pliers to remove or insert the jumper pin.

Rear Panel

Enhanced IDE compatible computers normally have two IDE interface

connectors; a primary one and a secondary one.

Each IDE interface connector of the host computer allows up to two

IDE devices to be connected. This means that a total of up to four IDE

devices can be connected.

Normally, a hard disk is connected to the primary connector, and a CD-

ROM drive is connected to the secondary connector.

Important:

Avoid connecting the CRW4261t or a CD-ROM drive to the same pri-

mary connector as the hard disk drive.

In order to take full advantage of the system's performance, we recom-

mend that you connect the CRW4261t to the secondary connector by

itself as the MASTER.

R G L

AUDIO OUT

CSEL

SLAVE

MASTER

IDE

INTERFACE

CONNECTOR

DC INPUT

15V

12V

Jumper Switch