Setup guide

6
ENGLISH
Eco9 can be installed in as little as 4 steps, and being plug-and-play, cameras
will be detected and recorded automatically.
Note: The Eco9 non-CD version has exactly the same connections as shown.
Connections at rear of the Eco9
Video
VID1 to VID9 - 75Ohm BNC composite camera connections (1V pk-pk)
MON A - Main monitor, 75Ohm BNC composite monitor connection
(1V pk-pk)
MON B - Spot monitor, 75Ohm BNC composite monitor connection (1V
pk-pk)
Data
SCSI - 50-pin HD SCSI-2 connection
NET - RJ-45 10-baseT Ethernet connection
SERIAL 1 - 9-way (Male) D-type RS-232 serial port (PPP modem)
Alarms and relays
ALARMS - 25-Way (Female) D-Type, programmable direct alarms;
NO/NC
RELAYS - 9-Way (Female) D-Type
Eco9 is available with an integral CD writer. The CD writer is accessible from
the front panel of the Eco9.
Front panel layout
Important Information
Selecting CD-R’s and CD-RW’s
The internal CD writer in the Eco9 is not compatible with the Ultra Speed
CDR’s. Ensure that only High Speed or Multi-Speed CDR media is used. This
is normally written on the CDR packaging and on the disk itself.
Quick Install