User Manual

Assembling the Clavinova
128
CLP-685, CLP-675, CLP-645, CLP-635, CLP-695GP, CLP-665GP Owner’s Manual
2. Attach two front legs and a rear leg.
Refer to the diagram below to verify the
orientation of the legs.
2-1. Install and tighten four screws on each leg,
starting with one of the front legs.
3. Install the pedal box.
3-1. Remove the twist tie that affixes the pedal
cord to the upper portion of the pedal box.
3-2. Align the cord with the groove on the unit,
and attach the pedal box using four screws.
3-3. Insert the pedal cord plug into the pedal
connector. Insert the plug so the arrow side
faces front (toward the keyboard). If the
plug will not go in easily, do not force it.
Double-check the orientation of the plug,
then try again.
Insert the pedal cord securely until the metal part
of the cord plug disappears from view. Otherwise,
the pedal may not function properly.
3-4. Attach the cord holder to the bottom of the
main unit as shown, then clip the holder
around the cord.
Rear leg
Front leg Front leg
6 × 40 mm fixing screws
Twist tieTape
6 × 20 mm fixing screws
3-3
3-4