Owner's Manual

49
English
CD-R/CD-RW COPYING
4
Initializing a CD-RW disc
This operation initializes a CD-RW disc.
1. Set a CD-RW disc in the disc tray, then press and
hold ERASE for about two seconds.
“Erase Disc ?” appears on the display.
To cancel erasing, press a.
2. Press w/d to start erasing.
“Erasing” flashes on the display, and the level meter shows the
erasing progress (the process takes about 20 minutes).
Notes
“Erase Last” and “Erase TOC” cannot be applied to a CD-RW
disc recorded with “Full Auto” (P.42) (except for adding track
data to a disc without finalization) or a CD-RW disc recorded
with duplication.
•Never turn off the power of this unit during erasing.
If “Check Disc” appears on the display during erasing, and
erasing stops, there may be dust or damage on the CD-RW disc.
Check the CD-RW disc and start the erasing operation again.
Erase Disc ?
CDR W
L
R
dB –30 –10 –6 –2 0
ERASING DATA ON A CD-RW DISC
104_HD1500(E)38-49.p65 3/22/05, 14:4949