Owner's Manual
Table Of Contents
- YFM4FGW Owner's Manual
- Introduction
- Important Manual Information
- Table of Contents
- Chapter 1 Safety Information
- Chapter 2 Location of the Warning and Specification Labels
- Chapter 3 Description
- Chapter 4 Instrument and Control Functions
- Chapter 5 Pre-Operation Checks
- Chapter 6 Operation
- Chapter 7 Riding your ATV
- Chapter 8 Periodic Maintenance and Minor Repair
- Chapter 9 Cleaning and Storage
- Chapter 10 Specifications
- Chapter 11 Consumer Information
- Index
8-52
8
2. Disconnect the headlight coupler by lifting the
tab as shown and pulling out the coupler.
3. Remove the headlight bulb holder assembly
by turning it counterclockwise.
NOTE:
The headlight bulb cannot be removed from the
headlight bulb holder. To replace the headlight
bulb, replace the headlight bulb holder assembly.
WARNING
EWB02180
1. Cover at the rear of the headlight
1. Headlight coupler
1. Headlight bulb holder assembly
POTENTIAL HAZARD
A headlight bulb is hot when it is on and im-
mediately after it is turned off.
U1P113E0.book Page 52 Friday, May 19, 2006 9:10 AM