User Manual

p
[REVERB] button
Turns the reverb on (the LED lights up yellow). This gives a natural-sounding reverberation.
q
[MUTE] button
Turns the mute on (the LED lights up red). You can use this to silence the sound when you take a short break or in
similar situations while livestreaming.
r
[PEAK] LED
This lights up when the input sound is too loud. If this lights up, turn the [GAIN] knob m counterclockwise to lower
the volume.
s
Fader (AG03MK2 only)
Adjusts the output volume for the sound that’s inputted from a mic or other source connected to (M) channel 1.
t
Level knobs
Adjusts the volume balance between channels.
AG06MK2
Adjusts the output volume for the sound that’s inputted from a mic or other source connected to (M) channel 1.
Adjusts the output volume for the sound that’s inputted from a guitar, mic or other source connected to (G/M)
channel 2.
Adjusts the output volume for the sound that’s inputted from an electronic keyboard or other source connected to
(K) channel 3/4.
Adjusts the output volume for the sound that’s inputted from audio equipment or another source connected to (R)
channel 5/6.
Adjusts the output volume for the sound that’s inputted from the (C/P) [USB 2.0] port.
AG03MK2
Adjusts the output volume for the sound that’s inputted from a guitar, electronic keyboard or other source connected
to (G/K) channel 2/3.
Adjusts the output volume for the sound that’s inputted from the (C/P) [USB 2.0] port.
u
[STEREO OUT] jacks (AG06MK2 only)
Outputs the mixed sound in stereo. Use this when connecting to another mixer, recorder or other equipment.
Compatible with phone plugs. The sound output from these jacks is unaffected by the settings of the [STREAMING
OUT] selector switch D or the speaker [S] knob F.
v
[MONITOR OUT] jacks (RCA pin type, AG03MK2 only)
Connect your powered monitor speaker or similar equipment here.
w
[MONITOR OUT] jack (phone type)
Connect your powered monitor speaker or similar equipment here. Compatible with phone plugs (balanced/
unbalanced)
x
[FOOT SW] jack
Connect a footswitch (such as a Yamaha FC5, sold separately) here. You can use a footswitch to mute the reverb
sound when the LED for the [REVERB] button p is on. The [EFFECT] button LED flashes when the effect sound is
muted. You can use AG Controller to configure the footswitch to mute channel 1 when you operate it.
y
Headphones [H] output jack
Connect your headphones or earphones here. Compatible with stereo phone plugs. When using headphones or
earphones with a stereo mini-plug, you can also use the [HEADSET] headphones [H] output jack z.
14
Component names and functions > Front side