Owner`s manual

Changes in UTILITY MODE

Chapter 2

Chapter 2 Upgrade Reference

Changes in UTILITY MODE

UTILITY - COMMAND Key - CREATE_OSC [Create Oscillators]

This is a new command. The command can be accessed from the UTILITY mode’s MAS-

TER function.

This command automatically generates the following seven “oscillator” samples: sine

wave, saw up, triangle, square, pulse 1, pulse 2, and pulse 3. To execute the command,

push Knob 1.

Note that the command will not create any samples for which matching sample names

already exist.

UTILITY - PANEL PLAY - KnobSet ☞ 292

Parameter assignments for Knobs 3 to 5 have been rearranged: Knob 3 now sets the Device,

Knob 4 sets the controller enable (Ctrl), and Knob 5 sets the transmit channel (T-ch).

•

On Version 1, the Device indication showed only the controller number. On Version 2,

it shows both the controller number and the corresponding device (if any). If you have

set up a knob to act as controller, then the knob name and transmit channel will both

appear next to the controller number (for example, 073/K4( 5) would indicate that

Knob 4 is set to operate as Controller 073 transmitting over Transmit Channel 5).

• The T-Ch (transmit channel) parameter at Knob 5 can now be set to AUDITION. If

you set the value to AUDITION, the knob will act as a controller during audition

replay.

UTILITY - SEQUENCE - SeqSel [Select Sequence] ☞ 296

Knob 5 now offers three operations: >NEW (create a new sequence; same as on Version

1), >SAVE (save the currently selected sequence), and >DELETE.(delete the currently

selected sequence). Turn the knob to select the operation, then push to execute.