Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
4-23
4
2. Remove the bolts, and then pull
the passenger seat off.
To install the passenger seat
1. Insert the projection on the pas-
senger seat into the holder as
shown.
2. Place the passenger seat in the
original position, and then install
the bolts.
3. Return the backrest to the original
position.
TIP
Make sure that the passenger seat is
properly secured before riding.
EAU14733
Adjusting the front fork
WARNING
EWA10180
Always adjust both fork legs equal-
ly, otherwise poor handling and loss
of stability may result.
This front fork is equipped with spring
preload adjusting bolts, rebound damp-
ing force adjusting knobs and compres-
sion damping force adjusting screws.
NOTICE
ECA10101
To avoid damaging the mechanism,
do not attempt to turn beyond the
maximum or minimum settings.
Spring preload
To increase the spring preload and
thereby harden the suspension, turn
the adjusting bolt on each fork leg in di-
rection (a). To decrease the spring pre-
load and thereby soften the
suspension, turn the adjusting bolt on
each fork leg in direction (b).
1. Rider seat backrest release lever
1. Bolt
2. Passenger seat
1
2
1
1. Projection
2. Seat holder
1
2
U2S312E0.book Page 23 Thursday, June 3, 2010 9:43 AM