Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
4-12
4
● Pushing “RESET” for at least two
seconds changes the screen to
the Normal mode.
● To perform further multi-function
display settings, enter the Select
mode again by pushing and hold-
ing “SELECT” and “RESET” for at
least three seconds.
Using the countdown clock:
The countdown clock can be activated
as follows.
1. Push “SELECT” to highlight “Stop-
watch”.
2. Push “RESET”.
3. Push “SELECT” to highlight
“Countdown”.
4. Push “RESET”. The multi-function
display changes to the Normal
mode, the stopwatch is displayed
in place of the clock, and the trans-
mission gear indicator changes to
the countdown clock.
5. Push “SELECT” or shift into gear
and the countdown clock starts
counting down from “5”. Simulta-
neously, the shift timing indicator
light flashes according to the num-
ber displayed (i.e., when “5” is dis-
played, the indicator light flashes
five times, when “4” is displayed,
the indicator light flashes four
times, etc.). The stopwatch starts
counting when the countdown
clock finishes counting.
6. Push the start switch “” or “SE-
LECT” to stop the countdown
clock.
7. Push “RESET” to reset the count-
down clock and stopwatch.
8. Repeat steps 5–6, or push “RE-
SET” again for at least two sec-
onds to enter the Normal mode.
TIP
To perform further multi-function dis-
play settings, be sure the transmis-
sion is in neutral, then enter the
Select mode again by pushing and
holding “SELECT” and “RESET” for at
least three seconds.
Checking and resetting the system sta-
tus
The status/readings of the following
items are displayed, and the tripmeters
can be reset.
● tripmeters and odometer
● fuel consumption
● air intake temperature
● throttle opening position
TIP
● The “System status” menu cannot
be entered if the fuel level warning
light or coolant temperature warn-
ing light is on.
● If, when the engine is running
while the system status menu is
displayed, the fuel level warning
U2S312E0.book Page 12 Thursday, June 3, 2010 9:43 AM