Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
4-14
4
EAU14583
Windshield [XV17ATSA(C)]
To suit the rider’s preference, the wind-
shield angle can be adjusted and the
height can be changed to one of two
positions.
To adjust the windshield angle
1. Loosen the bolts on each side of
the windshield.
2. Move the windshield to the desired
angle.
3. Tighten the bolts to the specified
torque.
To change the windshield height
1. Remove the bolts on each side of
the windshield.
2. Move the windshield to the other
position.
3. Install the bolts and tighten them to
the specified torque.
4. Loosen the screws holding the
windshield cover located above
the headlight, position the cover
close to the headlight without
touching it, and then tighten the
screws.
WARNING
EWA10920
After adjusting the windshield:
● Securely tighten the windshield
bolts.
● Turn the handlebar to the left
and right to make sure that the
handlebar is not obstructed and
that the windshield does not
contact any other parts.
1. Windshield
2. Bolt
Tightening torque:
Windshield bolt:
16 Nm (1.6 m·kgf, 12 ft·lbf)
1. Windshield
2. Bolt
Tightening torque:
Windshield bolt:
16 Nm (1.6 m·kgf, 12 ft·lbf)
1. Windshield cover
2. Screw
U1BH11E0.book Page 14 Monday, May 24, 2010 9:33 AM