Owner's Manual
Table Of Contents
- STAR XV19SX(C) XV19MX(C) OWNER'S MANUAL
- INTRODUCTION
- IMPORTANT MANUAL INFORMATION
- TABLE OF CONTENTS
- SAFETY INFORMATION
- DESCRIPTION
- INSTRUMENT AND CONTROL FUNCTIONS
- Main switch/steering lock
- Indicator and warning lights
- Multi-function meter unit
- Handlebar switches
- Clutch lever
- Shift pedal
- Brake lever
- Brake pedal
- Fuel tank cap
- Fuel
- Catalytic converter
- Rider seat
- Helmet holder
- Adjusting the shock absorber assembly
- EXUP system
- Sidestand
- Ignition circuit cut-off system
- Auxiliary DC connector
- PRE-OPERATION CHECKS
- OPERATION AND IMPORTANT RIDING POINTS
- PERIODIC MAINTENANCE AND MINOR REPAIR
- PERIODIC MAINTENANCE
- Owner's tool kit
- Periodic maintenance chart for the emission control system
- General maintenance and lubrication chart
- General maintenance and lubrication chart
- Checking the spark plugs
- Canister (for California only)
- Engine oil and oil filter cartridge
- Transfer case oil
- Air filter element
- Checking the throttle cable
- Valve clearance
- Tires
- Cast wheels
- Accessories and replacement parts
- Clutch lever
- Adjusting the rear brake light switch
- Checking the front and rear brake pads
- Checking the brake and clutch fluid levels
- Changing the brake and clutch fluids
- Drive belt slack
- Checking and lubricating the cables
- Checking and lubricating the throttle grip and cable
- Checking and lubricating the brake and shift pedals
- Checking and lubricating the brake and clutch levers
- Checking and lubricating the sidestand
- Lubricating the rear suspension
- Checking the front fork
- Checking the steering
- Checking the wheel bearings
- Battery
- Replacing the fuses
- Replacing a headlight bulb
- Tail/brake light
- Replacing a turn signal light bulb
- License plate light
- Supporting the motorcycle
- Troubleshooting
- Troubleshooting chart
- MOTORCYCLE CARE AND STORAGE
- SPECIFICATIONS
- CONSUMER INFORMATION
- INDEX
INSTRUMENT AND CONTROL FUNCTIONS
3-13
3
EAU38341
Helmet holder
The helmet holder is located under the
rider seat. A helmet holding cable is
provided beside the owner’s tool kit to
secure a helmet to the helmet holder.
To secure a helmet to the helmet
holder
1. Remove the rider seat. (See page
3-12.)
2. Pass the helmet holding cable
through the buckle on the helmet
strap as shown, and then hook the
cable loop over the helmet holder.
3. Place the helmet on the left side of
the vehicle, and then install the rid-
er seat.
CAUTION:
ECA15330
Be sure to place the helmet on the
left side of the vehicle. Some hel-
mets may contact the muffler when
placed on the right side because of
their size or shape.
WARNING
EWA10160
Never ride with a helmet attached to
the helmet holder, since the helmet
may hit objects, causing loss of con-
trol and possibly an accident.
To release the helmet from the hel-
met holder
Remove the rider seat, remove the hel-
met holding cable from the helmet hold-
er and the helmet, and then install the
seat.
1. Helmet holder
2. Helmet holding cable
1. Helmet holding cable
2. Helmet
U1D712E0.book Page 13 Wednesday, July 11, 2007 9:19 AM