Owner's Manual
Table Of Contents
- STAR XV19SX(C) XV19MX(C) OWNER'S MANUAL
- INTRODUCTION
- IMPORTANT MANUAL INFORMATION
- TABLE OF CONTENTS
- SAFETY INFORMATION
- DESCRIPTION
- INSTRUMENT AND CONTROL FUNCTIONS
- Main switch/steering lock
- Indicator and warning lights
- Multi-function meter unit
- Handlebar switches
- Clutch lever
- Shift pedal
- Brake lever
- Brake pedal
- Fuel tank cap
- Fuel
- Catalytic converter
- Rider seat
- Helmet holder
- Adjusting the shock absorber assembly
- EXUP system
- Sidestand
- Ignition circuit cut-off system
- Auxiliary DC connector
- PRE-OPERATION CHECKS
- OPERATION AND IMPORTANT RIDING POINTS
- PERIODIC MAINTENANCE AND MINOR REPAIR
- PERIODIC MAINTENANCE
- Owner's tool kit
- Periodic maintenance chart for the emission control system
- General maintenance and lubrication chart
- General maintenance and lubrication chart
- Checking the spark plugs
- Canister (for California only)
- Engine oil and oil filter cartridge
- Transfer case oil
- Air filter element
- Checking the throttle cable
- Valve clearance
- Tires
- Cast wheels
- Accessories and replacement parts
- Clutch lever
- Adjusting the rear brake light switch
- Checking the front and rear brake pads
- Checking the brake and clutch fluid levels
- Changing the brake and clutch fluids
- Drive belt slack
- Checking and lubricating the cables
- Checking and lubricating the throttle grip and cable
- Checking and lubricating the brake and shift pedals
- Checking and lubricating the brake and clutch levers
- Checking and lubricating the sidestand
- Lubricating the rear suspension
- Checking the front fork
- Checking the steering
- Checking the wheel bearings
- Battery
- Replacing the fuses
- Replacing a headlight bulb
- Tail/brake light
- Replacing a turn signal light bulb
- License plate light
- Supporting the motorcycle
- Troubleshooting
- Troubleshooting chart
- MOTORCYCLE CARE AND STORAGE
- SPECIFICATIONS
- CONSUMER INFORMATION
- INDEX
PERIODIC MAINTENANCE AND MINOR REPAIR
6-28
6
To replace the high beam headlight
bulb
1. Remove the headlight bulb holder
cover by turning it counterclock-
wise.
2. Disconnect the headlight coupler,
and then unhook the headlight
bulb holder.
3. Remove the defective bulb.
WARNING
EWA10790
Headlight bulbs get very hot. There-
fore, keep flammable products away
from a lit headlight bulb, and do not
touch the bulb until it has cooled
down.
4. Place a new headlight bulb into po-
sition, and then secure it with the
bulb holder.
CAUTION:
ECA10650
Take care not to damage the follow-
ing parts:
● Headlight bulb
Do not touch the glass part of
the headlight bulb to keep it free
from oil, otherwise the transpar-
ency of the glass, the luminosity
of the bulb, and the bulb life will
be adversely affected. Thor-
oughly clean off any dirt and fin-
gerprints on the headlight bulb
using a cloth moistened with al-
cohol or thinner.
● Headlight lens
Do not affix any type of tinted
film or stickers to the headlight
lens.
Do not use a headlight bulb of a
wattage higher than specified.
1. Screw
1. Headlight bulb holder cover
1. Headlight coupler
2. Headlight bulb holder
U1D712E0.book Page 28 Wednesday, July 11, 2007 9:19 AM