Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
6-36
6
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screws.
CAUTION:
ECA10680
Do not overtighten the screws, oth-
erwise the lens may break.
EAU24321
Replacing a license plate light
bulb
1. Remove the license plate light unit
by removing the nuts, washers and
rubber dampers.
2. Remove the license plate light lens
by removing the nuts and washers.
3. Remove the defective bulb by pull-
ing it out.
4. Insert a new bulb into the socket.
5. Install the license plate light lens
by installing the washers and the
nuts.
6. Install the license plate light unit by
installing the rubber dampers,
washers and the nuts.
1. Turn signal light bulb
1. Nut
2. Washer
3. Rubber damper
4. License plate light unit
1. Nut
2. Washer
3. Bulb
4. License plate light lens
U5PX15E0.book Page 36 Tuesday, May 16, 2006 10:10 AM